Tera Scanner HW0010

The model Tera Scanner Model HW0010 does not support reading AIM Code. However, it allows the Code ID to be sent, which, while not the same as AIM Code, allows differentiating the type of barcode being read. Thus, the configurations to be made are as follows:

Instructions

1. Indicate that you want to add a prefix:

2. Indicate which prefixes to add (in this case, it will be the character ] followed again by the character ] ):

Add the first character ]

Add the second character ]

Configure the Code ID:

Code ID On

(note: when reading this code, the scanner will not make any sound; only the laser will disappear)

Test

Read the barcode below and check the result. The scanner should write the following code: ]]m5930383

Attention: If other characters appear instead of ]] this means that the scanner's language differs from that of the equipment it is connected to. You should try to set the language to match that of the equipment.

If the language of the equipment to which the scanner is connected is Portuguese, read the codes below (try one at a time):

To disable Code ID, you must read the code below:

To disable the ]] prefix, follow these steps:

1. Read the following code:

2. Then, read the following code: